Instruction Manual

14
en
Control panel
ON/Stand-by
Button
Laundry
Button
Dehumidifying
Button
Timer Button Fan Button
Decrease
Button
Display
Thermometer
/ Hygrometer
button
Increase
Button
Button descriptions
”ON/Stand-by” Button
This turns the appliance on / o.
Dehumidifying Button
This starts the dehumidifying mode. Press the button repe-
atedlytoselectthedesireddehumidifyinglevel(MIN/MED/
MAX/AUTO).
Laundry Button
This starts the laundry mode.
Fan Button
This starts the fan mode. Press the button repeatedly to
selectthedesiredlevelofventilation(MIN/MED/MAX).
Hygrometer/Thermometer Button
This temporarily displays the temperature and the level of hu-
midity detected in the room where the appliance is installed.
Timer Button
This allows you to set the timer mode to delay when the ap-
pliance comes on or goes o.
Increase/Decrease Buttons
These allow you to set the percentage of humidity you wish
toachieveintheroom,byincreasingordecreasingitby5%
at a time. It is also possible to set the timer using these but-
tons.From0to10hthetimeisadjustedby30-minuteincre-
ments, and from 10 to 24 h the time is adjusted by 1-hour
increments.
Description of the Display
The meanings of the codes or symbols which may appear on
the display:
Stand-by
This indicates that the appliance is in Stand-by mode.
Tank Alarm
If this symbol appears it means that the tank is full, absent or
incorrectly positioned.
This alarm continues until the tank is correctly positioned.
Defrost alarm
At low temperatures, the appliance frequently carries out
defrost cycles.
During defrost this symbol will appear.
Sensor alarms
This indicates a possible malfunction of the sensors or that
the ambient humidity is too low to be detected.
Keyboard Lock
This symbol appears when the keyboard lock is enabled.
Nota Bene: with the aim of saving energy, after the
appliance has been in stand-by for a few minutes, the display
will go o.