User Manual

7
TROUBLESHOOTING
In case “PF” is displayed and a warning sound is emitted,
there is a fault on the temperature sensor. If the problem
persists contact the Service Center.
If the appliance shuts o unexpectedly:
- Check that the appliance is receiving power.
- Check that the appliance is in the vertical position and
on a at surface, as the safety tip-over switch may have
been tripped.
- Check the temperature set and the timer: the appliance
may be o because the set temperature has been
reached or the time set on the timer has elapsed.
MAINTENANCE
- Before carrying out any maintenance, always unplug
from the outlet.
- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
- Never use abrasive powders or solvents to clean the
appliance.
- The dust lter which retains impurities in the air, It is
integrated in the removable back cover. To clean the
lter, remove the grille by pulling outward. Blow it
lightly, then replace it into the appliance.
PROBLEM CAUSE SOLUTION
PF display
Temperature sensor is not working
properly
The product needs to be serviced, contact
our toll free number for assistance
If the appliance shuts o
unexpectedly
Check that the appliance is receiving
power.
Delayed shut-o is activated
Room temperature reaches the set
temperature
Plug in
Wait till time elapsed or press the button
(E) twice to cancel the function and push
the button (A)
Use the “+” button to increase the set
temperature
A dot is ashing and unit is o The tip-over switch has been activated Make sure the appliance is standing
upright on a at surface, if the problem
persists contact our toll free number to
assist you
The display shows "Ht" blinking
The internal temperature is too high.
The air intake or outlet grille is
obstructed
Check the appliance is correctly positioned
respecting the minum distances from
the wall, or objects, as indicated on the
instruction manual, if not, position the
appliance correctly
Remove the obstruction
Disconnect the plug from the outlet and
let the appliance cool down. After few
minutes plug the appliance again. If the
appliance doesn't work please contact the
De longhi toll free number
TROUBLESHOOTING