Operation Manual

21
EN
Troubleshooting - Electrical connection
Problem Possible causes Solution
The milk does not froth when making a
cappuccino
The milk is not cold enough Always use milk at fridge temperature
The milk-frother is dirty Clean the small holes in the milk-frother very
carefully, particularly those indicated in g. 27
The lter or espresso coee has an acidic
avour
Insucient rinsing after the de-scaling operation Rinse the appliance as described in the chapter
“De-scalingoftheltersection”or“De-scalingofthe
espressosection”
The time taken to percolate the lter cof-
fee is getting longer
The coee-maker lter needs de-scaling Carry out the de-scaling procedure as described in
theparagraph“De-scalingoftheltercoeesection”
Electrical connection (UK only)
Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt
about your supply contact your local electricity company.
The exible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not t the socket outlets
in your home, it should be cut o and replaced with a suitable plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left where children might nd it and
plug it into a supply socket - with the obvious consequent danger.
N.B. We recommend the use of good quality plugs and wall sockets that can be switched o when the machine is not in use.
IMPORTANT: the wires in the mains lead tted to this appliance are coloured in accordance with the following code:
green and yellow earth
blue neutral
brown live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
- The wire which is coloured green and yellow must be connected to the terminal in the plugwhichismarkedwiththeletterEorbytheearth
symbol or coloured green or green and yellow.
- The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
- ThewirewhichiscolouredbrownmustbeconnectedtotheterminalwhichismarkedwiththeletterLorcolouredred.
Whenwiringtheplug,ensurethatallstrandsofwirearesecurelyretainedineachterminal.Donotforgettotightenthe mains lead
clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualied electrician.
Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualied electrician and should only be replaced
with a exible cord of the same size.
After replacement of a fuse in the plug, the fuse cover must be retted. If the fuse cover is lost, the plug must not be used until a replacement cover is
obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always
state this colour when ordering a replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362 should be tted.
ThisapplianceconformstotheNormsEN55014regardingthesuppressionofradiointerference.
Warning - this appliance must be earthed
Green and Yellow to Earth
13 amp
Fuse
Brown to
live
Cord Clamp
Blue to
neutral