Operation Manual

PROBLEM POSSIBLE CAUSES SOLUTION
Espresso coffee drips from the
edges of the filter holder,
instead of from its holes.
The coffee has an acidic taste.
• Lack of water in the tank.
• The holes in the filter holder spouts
are blocked.
• The outlet of the espresso boiler is
blocked.
• The tank is badly inserted and the
valve at the bottom is not open.
• Fill the water tank.
• Clean the holes in the spouts.
• Clean as indicated in the “Cleaning
the espresso boiler outlet” section.
•Press the tank lightly so as to open
the valve at the bottom.
•
The filter holder is badly inserted.
• The gasket of the espresso boiler has
lost elasticity.
• The holes in the filter holder spouts
are blocked.
• Attach the filter holder on correctly
and turn it all the way.
• Have the espresso boiler gasket
replaced at an Service Centre
• Clean the holes in the spouts.
The espresso coffee is cold.
•
The ‘OK’ pilot light was not on when
the coffee delivery switch was pres
sed.
• The preheating was not carried out.
• The cups were not preheated.
•
Wait until the OK pilot light comes
on.
• Carry out the preheating as indica
ted in the “Preheating the coffee
unit” section.
• Preheat the cups by rinsing them in
hot water.
The pump is too noisy.
• The water tank is empty.
•
The tank is inserted wrongly and the
valve at the bottom is not open.
• Fill the tank.
•
Press the tank lightly so as to open
the valve at the bottom.
The milk does not frothwhen
making a cappuccino.
•
The milk is not cold enough.
• The cappuccino maker is dirty.
• Always use milk at refrigerator tem
perature.
• Carefully clean the pinholes in the
milk frother
The coffee cream is light-
coloured (the coffee comes out
quickly from the spout).
• The ground coffee has not been
pressed enough.
• The quantity of ground coffee is
scarce.
• The coffee is not ground finely
enough.
•Tamper the ground coffee down
more.
•
Increase the quantity of coffee.
• Only use coffee specifically ground
The coffee cream is dark (the
coffee comes out slowly from
the spout).
• The ground coffee is too tightly pres
sed.
• The quantity of ground coffee is too
much.
• The espresso boiler outlet is blocked.
• The coffee is too finely ground.
•Press the coffee less.
• Decrease the quantity of ground cof
fee.
•
Clean the outlet as described in
“Cleaning the espresso boiler outlet”
section.
• Only use coffee specifically ground for
espresso coffee machines.
• The unit was not sufficiently rinsed
after the descaling process
procedure.
• Rinse the unit as described in the
“descaling” section.
15
Espresso coffee no longer
comes out.