User Manual

Cooker hood

INSTALLATION INSTALLATION

According to the Fig.3, make sure the position of the hoods on the

wall. Then use the stencil to drill four Φ8 holes on the wall. Fix four

sets expanding plugs and screws aimed at the four holes.

Φ8

Hang the hood and let it's 4 installation holes aim at 4 screws,

Adjust it to setting position.

Fixing the cooker hood

Ensure the power has been turned off before beginning this installation.

10M M

Please make sure the outside dimension of the screws is 10mm.

Screw down the four crews. first screw down the upper two screws,

then screw down the nether two screws.

You will need the following tools and material to complete this

installation:

*Drill* Flat head screwdriver* Phillips head screwdriver or cordless drill

and Phillips head bit* Tin snips*3/8″nut driver or ratchet with extension

*measuring tape* hand saw or jig saw*electrical tape*duct tape

1. Remove the hood from the carton.

2. Lay the hood upside down on a table covered with cardboard or paper

to prevent scratching of the table or hood.

3. Hood installation should be within 0.8m radius range from the socket.