Quick Start Guide

6
DESCRIPTION
A Warning lamp
B Thermostat
C Power selector
General instructions
Remove the appliance from the packaging.
Check that neither the appliance nor the power cable has
been damaged during transport. Do not operate the heater if
damaged. Remove all publicity material from the appliance.
Electrical connection
- Before connecting the appliance to the power socket,
check that the voltage indicated on the appliance rating
plate is the same as your electrical system and that it can
support the power consumption (Watt) indicated.
- If more than one appliance is used at the same time, it is
important to ensure that the electrical system is able to
support the power required.
Use on the oor, feet assembly
Tools required:
Screwdriver PH2x100 (crosshead)
2 supplied screws 3.5x13 PH (F)
Place the appliance on a stable surface.
For mounting the feet, proceed as follows:
- Insert the two hooks in the slots and rotate the foot until
it is engaged as shown in gure 1.
- Insert the two pins in their respective holes.
- Fix the foot with the screw (F) supplied (gure 2).
- See Figure 3 for the minimum distances of the device
from the walls. The measurements are indicated both
for models equipped with fan " " and for models
without.
Important! never use the appliance without feet.
USE
Operation and use
Insert the plug into the socket and switch on at the socket if
necessary, turn the thermostat knob (B ) to position 6 and
turn the appliance on via the power selector ( C ) as follows:
• The warning lamp ( A ) lights up.
• Turn the power selector knob to Min to select minimum
power.
• Turn the power selector knob to Med to select medium
power.
• Turn the power selector knob to Max to select
maximum power.
• To switch o the appliance completely: turn the
power selector to "0" and the thermostat to , then
disconnect at the power socket.
Adjusting the thermostat
When the room has reached the required temperature, turn
the thermostat knob (B) slowly anticlockwise until you hear a
click and no further. The warning lamp ( A ) goes out.
The thermostat will automatically maintain the temperature.
In spring or autumn or on mild days, you can save energy by
using minimum power.
Freezing protection
With the knob of the thermostat (B) in position and one
of the power levels selected, the appliance will maintain the
room at a temperature of about 5°C preventing freezing with
minimum energy consumption.
Models with fan
The appliance is equipped with a fan that provides even more
rapid and uniform heating.
To start this function, turn the power selector (C ) to Max .
MAINTENANCE
Before carrying out any maintenance, disconnect the
appliance from the power supply and wait for it to cool down
completely.
This appliance requires no particular maintenance.
It is sucient to remove dust with a soft, dry cloth. Never use
abrasive powders or solvents.
If necessary remove areas of concentrated dirt with a vacuum
cleaner.
TECHNICAL CHARACTERISTICS
Power supply See appliance rating plate
Power consumption "