Instruction Manual

9
HOW TO USE THE TIMER
To program heating, proceed as follows (g.7):
- Look at the time on your clock or watch. If it is 10 p.m.,
turn the numbered timer disk clockwise until the num-
ber 22 (10 p.m.) on the disk coincides with the pointer
s (3) on the timer. Set the periods of time when you
want the appliance to work by pushing the teeth (1)
inward.
Each tooth (1) corresponds to a period of 15 minutes.
This will leave visible sectors which correspond to the
periods of operation (2). When set, the radiator will
operate automatically each day during the times pro-
grammed (important: the radiator must always be
plugged into the socket).
- To change the programming, move the teeth back into
the initial position and set the new periods of operation.
- To turn the appliance o completely, as well as press the
switches to the 0 position, you must also unplug it from
the power outlet to avoid continued operation of the
timer.
IMPORTANT: DO NOT ROTATE CLOCK DIAL COUNTER-
CLOCKWISE.
The timer is like an electric clock, and will only work when
plugged into a power supply. When unplugged, the timer
stops and must be later re-set.
Timer override (only on some models)
If you wish to override the timer settings, push the timer
switch to position I (g.8) manual (timer override). To return
to timed operation push the switch back to the middle posi-
tion (g.8).
NOTE: if the timer switch is at the 0 position (g. 8),
the heater is o and will not operate).
MAINTENANCE
Before carrying out any operation on the radiator, unplug
from the electric mains and wait for it to cool.
The oil-lled electric radiator requires no particular mainte-
nance. It is sucient to remove the dust with a soft, dry cloth.
Never use abrasive powders or solvents. If necessary remove
concentrations of dirt using a vacuum cleaner.
TECHNICAL CHARACTERISTICS
Supply voltage See rating label
Absorbed power “
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The appliance doesn't work Be sure it is plugged in and that the elec-
trical outlet is working.
Check for any obstruction.
The temperature may be set too low.
Plug into the power outlet.
Remove the obstruction and let the appli-
ance cool down. If the appliance doesn't work
please contact Customer Experience.
Set the temperature to a higher position.