Product Manual

Page 14 of 32

All wood materials: 15%

Drywall: 1.0%

Concrete: 68 (on the 0-100 relative scale)

TO TAKE PIN READINGS IN ENHANCED MODE:

1. From the Enhanced Main Menu, use the

  keys to highlight #1, PIN MODE.

2. Press the SELECT key to get into the ENHANCED READ screen. The current

location will stay the same while toggling between scan and pin modes.

This screen contains the following information: material, pin setting, temperature

correction, Job #, alarm setting, mode, and memory used.

3. Insert the pins into the material. The meter will start taking measurements in

one of the two following ways, depending on whether it is set for CONTINUOUS

or TRIGGERED mode. To choose between TRIGGERED or CONTINUOUS, use

the

  and   keys to highlight MODE, and then press the SELECT key to

toggle between TRIG and CONT.

• When the meter is set to Triggered mode, a single reading is taken

every time the SELECT button is pressed. Each reading is stored in

memory. The last measurement remains displayed on the screen.

• When the meter is set to Continuous mode, press SELECT key to

initiate the reading cycle. The meter keeps taking MC readings in this

mode. These readings are NOT stored until the SELECT key is pressed

again. To exit continuous mode WITHOUT STORING the current reading,

press any directional key (  and  ).

To exit continuous mode

and STORE the current reading, press the SELECT key. Exiting

continuous mode leaves the last reading on the screen. To resume

continuous mode, press the SELECT key again. Use the

  and

  keys to choose a different option.

4. At any time, you may modify Temperature (T).

The EXIT option in both SCAN and PIN MODE menus will cancel the

measurement process and will put the meter in the MAIN MENU.

TO TAKE SCAN READINGS IN ENHANCED MODE: