Product Manual

Page 11 of 32

2. The meter will begin taking readings. As a default setting the RH reading will

be the most prominent on the screen. If you would like to make another variable

(temperature, GPP/GPK or dew point), the prominent reading, use the

 and

  keys to highlight your selection. Press the SELECT key to choose that

variable.

TO RESET THE METER TO DEFAULT SETTINGS IN BASIC MODE:

1. Use the

  keys from the BASIC main menu to highlight #4: DEFAULTS.

Press the SELECT key. The meter will display the following question:

2. Use the

  keys to answer “YES” or “NO.” If you answer “yes,” the meter

will return to factory default settings in basic mode; i.e. Species = Douglas Fir,

Temperature correction = 70 F, Alarm = OFF in pin mode. In Scan mode, Alarm

= “off.”

USING THE METER IN ENHANCED MODE:

To use TotalCheck in enhanced mode, use the

  keys to highlight #5: ENHANCED.

Setting the meter to enhanced mode requires you to create job definitions and store

readings as described below.

NOTE: Although TotalCheck’s default mode is BASIC, it will remember the mode

last saved at power off, and will remain in the saved mode at next power up.

Settings stored in each particular mode will not be affected by restoring defaults

in a different mode.

JOB DEFINITION:

Using TotalCheck in ENHANCED mode allows you to define jobs. In this mode,

TotalCheck also stores each reading and allows you to download the data to a PC or