Product Manual

Page 11 of 30

°F mode, Absolute Humidity will be displayed in GPP. When in °C mode, Absolute

Humidity will be displayed in GPK.

TO RESET THE METER TO DEFAULT SETTINGS IN BASIC MODE:

1. Use the  keys from the BASIC main menu to highlight #5: DEFAULTS. Press

the SELECT key. The meter will display the following question:

2. Use the  keys to answer “YES” or “NO.” If you answer “yes,” the meter will

return to factory default settings in basic mode; i.e. Species = Oak, Temperature

correction = 70° F, Alarm = OFF in pin mode. In Scan mode, Alarm = OFF.

USING THE METER IN ENHANCED MODE:

To use Navigator Pro in enhanced mode, use the  keys to highlight #4: ENHANCED. The

Main Menu in ENHANCED mode is as follows:

Setting the meter to enhanced mode requires you to create job definitions and store readings as

described below.

NOTE: Although Navigator Pro’s default mode is BASIC, it will remember the mode last

saved at power off, and will remain in the saved mode at next power up.

Settings stored in each particular mode will not be affected by restoring defaults in a

different mode.

JOB DEFINITION:

Using Navigator Pro in ENHANCED mode allows you to define up to 5 jobs, and select locations

and materials being tested for each location. In this mode, Navigator Pro also stores each

reading and allows you to download the data to a PC or laptop via Infrared connection.

TO CREATE OR MODIFY A JOB: