Personal Computer User Manual

Beep Codes and System Messages A-13
WARNING: Could not
configure
Plug and Play
Card Name
.
WARNING: Could not con-
figure PCI device,
ID=
DeviceID
.
Failed to configure
Number
of
Total Count
Plug and Play ISA
devices. Use your sys-
tem’s configuration
utility to resolve con-
flicts. Press any key
to continue.
The card(s) mentioned are not
fully configured due to
resource conflicts.
If you have documentation that lists the allow-
able resource values for your Plug and Play or
PCI expansion card, you can use the following
procedure to locate and resolve the resource
conflict (otherwise, see the next entry in this
table):
1. Start the ISA Configuration Utility.
Any Plug and Play or PCI cards that could
not be configured should be marked
“
config err
” on the list of cards in the
ISA Configuration Utility window.
2. Select the System Resources option from
the View menu.
The System Resource Usage dialog box
displays all resources currently used by the
system.
3. Select one of the resources used by your
Plug and Play or PCI expansion card,
and click the Used by Card button.
The Card Resources Usage dialog box dis-
plays the information.
4. Repeat step 3 until you have identified all
conflicted resources and the cards that
use them.
5. Modify the cards as needed to free the
resources required by the unconfigured
Plug and Play or PCI expansion card.
For instructions, see “Modifying a Card” in
the configuring expansion cards section of
the online System User’s Guide.
Table A-4. Configuration Manager Messages
(continued)
Message Probable Cause Corrective Action
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.