Service Manual

Перед роботою зі внутрішніми

компонентами комп'ютера

ПРИМІТКА: The images in this document may differ from your computer depending on the configuration you ordered.

Перед початком роботи

1. Збережіть та закрийте всі відкриті файли, вийдіть з усіх відкритих програм.

2. Вимкніть комп'ютер. Натисніть Розпочати >

Живлення > Завершити роботу.

ПРИМІТКА: Якщо ви використовуєте іншу опраційну систему, див. інструкції щодо завершення роботи в

документації до операційної системи.

3. Відключіть комп'ютер та всі під'єднані пристрої від електричної мережі.

4. Від'єднайте від комп'ютера усі під'єднані мережеві та періферійні пристрої, такі як клавіатура, миша та монітор.

5. Витягніть із комп'ютера картки пам'яті та оптичні диски, якщо такі є.

Safety instructions

Use the following safety guidelines to protect your computer from potential damage and to ensure your personal safety. Unless otherwise

noted, each procedure included in this document assumes that you have read the safety information that shipped with your computer.

NOTE:

Before working inside your computer, read the safety information that shipped with your computer. For more

safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.

NOTE: Disconnect all power sources before opening the computer cover or panels. After you finish working inside the

computer, replace all covers, panels, and screws before connecting to the electrical outlet.

CAUTION: To avoid damaging the computer, ensure that the work surface is flat and clean.

CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by

its edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.

CAUTION: You should only perform troubleshooting and repairs as authorized or directed by the Dell technical

assistance team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. See the safety

instructions that shipped with the product or at www.dell.com/regulatory_compliance.

CAUTION: Before touching anything inside your computer, ground yourself by using a wrist grounding strap or by

periodically touching an unpainted metal surface, such as the metal at the back of the computer. While you work,

periodically touch an unpainted metal surface to dissipate static electricity, which could harm internal components.

CAUTION: When you disconnect a cable, pull on its connector or on its pull tab, not on the cable itself. Some cables have

connectors with locking tabs or thumb-screws that you must disengage before disconnecting the cable. When

disconnecting cables, keep them evenly aligned to avoid bending any connector pins. When connecting cables, ensure

that the ports and connectors are correctly oriented and aligned.

CAUTION: Press and eject any installed card from the media-card reader.

NOTE: The color of your computer and certain components may appear differently than shown in this document.

Перед роботою зі внутрішніми компонентами комп'ютера 7