Service Manual

• Computer is in sleep state, hibernation, or turned off.

The power and battery-status light blinks amber along with beep codes indicating failures.

For example, the power and battery-status light blinks amber two times followed by a pause, and then blinks white three times followed by

a pause. This 2,3 pattern continues until the computer is turned off indicating no memory or RAM is detected.

The following table shows different power and battery-status light patterns and associated problems.

Table 18. LED codes

Diagnostic light codes Problem description

2,1 Processor failure

2,2 System board: BIOS or ROM (Read-Only Memory) failure

2,3 No memory or RAM (Random-Access Memory) detected

2,4 Memory or RAM (Random-Access Memory) failure

2,5 Invalid memory installed

2,6 System-board or chipset error

2,7 Display failure

3,1 Coin-cell battery failure

3,2 PCI, video card/chip failure

3,3 Recovery image not found

3,4 Recovery image found but invalid

3,5 Power-rail failure

3,6 System BIOS Flash incomplete

3,7 Management Engine (ME) error

Camera status light: Indicates whether the camera is in use.

• Solid white — Camera is in use.

• Off — Camera is not in use.

Caps Lock status light: Indicates whether Caps Lock is enabled or disabled.

• Solid white — Caps Lock enabled.

• Off — Caps Lock disabled.

Troubleshooting