Service Manual

Steps

1. Loosen the captive screw (M1.6x3) that secures the display-cable bracket to the system board.

2. Lift the display-cable bracket off the system board.

3. Peel the tapes that secure the display cable and camera cable to the system board.

4. Using the tape as a pull tab, disconnect the display cable and camera cable from the system board.

5. Remove the display cable and camera cable from the routing guides on the system board.

6. Remove the four screws (M2.5x3) that secure the display hinges to the palm-rest assembly.

7. Slide the palm-rest assembly off the display assembly.

Removing and installing components