Owners Manual

For instructions, see the documentation accompanying the card.
2. Lift the expansion-card latch and remove the filler bracket.
3. Holding the card by its edges, position the card so that the connector on the expansion card aligns
with the expansion-card connector on the riser.
4. Insert the card-edge connector firmly into the expansion-card connector until the card is fully
seated.
5. Press the touch points to open the expansion-card locking tabs.
6. Replace the expansion-card latch.
7. If applicable, connect the cables to the expansion card.
Next steps
1. Follow the procedure listed in After working inside your system.
2. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion-card risers
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If installed, remove any expansion card installed on riser 2 and 3.
Steps
Holding the slots on the expansion-card riser, lift the riser from the riser connector on the system
board.
NOTE: To remove expansion-card risers 2 and 3, hold the edges of the expansion-card riser.
NOTE: To ensure proper system cooling, the riser 1 blank must be installed in the riser 1 slot.
Remove the riser 1 blank only if you are installing riser 1.
75