Owners Manual

Figure 3. HDD indicators on the hard-drive tray backplane

1. Hard drive activity indicator 2. Hard drive status indicator

3. Hard drive backplane on hard-drive tray

NOTE: If the hard drive is in Advanced Host Controller Interface (AHCI) mode, the status indicator

(on the right side) does not function and remains off.

Table 4. Drive-status indicator pattern

Drive-status indicator pattern Condition

Blinks green two times per second Identifying drive or preparing for removal. HDD or

SSD location is enabled for one or more HDDs or

SSDs is in the failed state on the Nutanix Web GUI.

Off Drive ready for insertion or removal.

NOTE: The drive status indicator remains off

until all hard drives are initialized after the

system is turned on. Drives are not ready for

insertion or removal during this time.

Blinks green, amber, and turns off Predicted drive failure

Blinks amber four times per second Drive failed

Blinks green slowly Drive rebuilding

Steady green Drive online

Blinks green three seconds, amber three seconds,

and turns off six seconds

Rebuild aborted

iDRAC Direct LED indicator codes

This topic describes about the iDRAC Direct LED indicator codes.

NOTE: The iDRAC Direct LED indicator does not glow for the USB mode.