Support Matrix
Table Of Contents
- 1.1 Supported hardware, firmware and software
- 1.2 Supported components
- 1.3 Validated BIOS and iDRAC versions
- 1.4 Supported physical disk drives
- 1.5 Supported HBAs
- 1.6 Supported networking
- 1.7 Supported hardware management solutions
- 1.8 Supported Nutanix AOS software
- 1.9 Supported hypervisor OS
- 1.10 Driver support
- 2 Technical specifications
- 3 Documentation matrix
- 4 Contacting Dell EMC
- 5 Quick Resource Locator
Technical specifications
13 Dell EMC XC730xd-12C Series Hyper-Converged Appliance Support Matrix | A26
Memory
Specification
64 GB with a dual processor
2.6 Hard drive specification
This section provides hard drive specifications for your hardware.
Hard drive specification
Type
Specification
Twelve hard-drive systems
Up to twelve 3.5- inch drives
2.7 Connector specifications
This section provides connectors specifications for your hardware, including rear, front, and internal
connectors.
Connector specifications
Type
Specification
Rear
NIC
Two 1 Gbps plus two 10 Gbps
Serial
9-pin, DTE, 16550-compatible
USB
Two 4-pin, USB 3.0-compliant
Video
15-pin VGA
External vFlash card
One flash memory card slot with iDRAC8 Enterprise
card
NOTE: The card slot is available for use only if
the iDRAC8 Enterprise license is installed on
your system.
Front
USB
One 4-pin, USB 2.0-compliant
One USB management port or iDRAC Direct
Video
15-pin VGA
Internal
USB
One 4-pin, USB 3.0-compliant
Internal Dual SD Module
(IDSDM)
Two flash memory card slots with one internal SD
card.