Owners Manual

CAUTION: To avoid damage to the battery connector, you must firmly support the connector

while installing or removing a battery.

2. Place your finger between the securing tabs at the negative side of the battery connector and lift the

battery out of the socket.

Figure 40. Removing the system battery

1. positive side of the battery connector 2. system battery

3. negative side of the battery connector

3. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing

tabs.

4. Press the battery into the connector until it snaps into place.

Figure 41. Installing the system battery

1. system battery 2. positive side of the battery

Next steps

1. Install the cooling shroud.

2. Follow the procedure listed in After working inside your system.

3. While booting, press F2 to enter System Setup and ensure the battery is operating properly.

4. Enter the correct time and date in System Setup Time and Date fields.

5. Exit System Setup.

Power supply units

Your system supports one of the following: