Owners Manual

Steps

1. Pull the tab to release it from the notch and slide the cable retention bracket toward the front of the

chassis to release it from the chassis.

2. Lift the cable retention bracket out of the chassis.

Figure 26. Removing and installing the cable retention bracket

1. alignment pin (2) 2. tab

3. cable retention bracket

Next steps

1. Replace the cable retention bracket. See Installing the cable retention bracket.

2. Follow the procedure listed in After working inside your system.

Installing the cable retention bracket

Prerequisites

1. Ensure that you read the Safety instructions.

2. Follow the procedure listed in Before working inside your system.

3. Remove the cooling shroud.

4. Remove the PCIe card holder.

CAUTION: Many repairs may only be done by a certified service technician. You should only

perform troubleshooting and simple repairs as authorized in your product documentation, or as

directed by the online or telephone service and support team. Damage due to servicing that is

not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that are shipped with your product.

Steps

1. Align the cable retention bracket with the alignment pins on the chassis.

2. Slide the cable retention bracket along the chassis wall until the tab clicks and locks the slots.

3. Place all cables to be routed in the cable retention bracket.

Next steps

1. Install the PCIe card holder.