Owners Manual

Table Of Contents

Follow the safety guidelines listed in the Safety instructions section.

1. Holding the system board by the edges, slide the system board into the system board assembly.

2. Install the screws to secure the system board to the system board assembly.

1. Install the Trusted Platform Module (TPM). For information how to install the TPM, see the Installing

the Trusted Platform Module section. For more information on the TPM, see the Trusted Platform

Module section.

NOTE: The TPM plug-in module is attached to the system board and cannot be removed. A

replacement TPM plug-in module will be provided for all system board replacements where a

TPM plug-in module was installed.

2. Transfer the processors to the new system board.

3. Remove the memory modules and transfer them to the same locations on the new board.

4. Replace the heat sinks.

5. Install the expansion card assembly.

6. If applicable, install the SAS mezzanine card, 1 GbE mezzanine card, or 10 GbE mezzanine card.

7. Connect all the cables to the system board.

8. Install the cooling shroud.

9. Follow the procedure listed in the After working inside your system section.

10. Import your new or existing iDRAC Enterprise license. For more information, see Integrated Dell

Remote Access Controller User's Guide, at Dell.com/esmmanuals.

11. Ensure that you:

a. Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy

restore section.

b. If the Service Tag is not backed up in the backup flash device, enter the system Service Tag

manually. For more information, see the Entering the system Service Tag section.

c. Update the BIOS and iDRAC versions.

d. Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the

Trusted Platform Module (TPM) section.