Owners Manual
Table Of Contents
- Dell XC6320 Web-Scaled Hyperconverged Appliance Owner's Manual
- About the Dell XC6320
- About your system
- Accessing system features during startup
- Front panel features and indicators
- Hard drive indicator patterns
- Back panel features and indicators
- System-board assembly configurations
- LAN indicator codes
- Power and system board indicator codes
- Power Supply Unit indicator codes
- iDRAC heart beat LED
- Documentation references
- Performing initial system configuration
- Pre-operating system management applications
- Navigation keys
- System Setup
- Entering System Setup
- System Setup details
- System BIOS Settings details
- System Information details
- Memory Settings details
- Processor Settings details
- SATA Settings details
- Boot Settings details
- Network Settings screen details
- Integrated Devices details
- Serial Communication details
- System Profile Settings details
- System Security Settings details
- Miscellaneous Settings details
- System setup options at boot
- About Boot Manager
- Changing the boot order
- Choosing the system boot mode
- Assigning a system and setup password
- Deleting or changing system and setup password
- Installing and removing system components
- Safety instructions
- Recommended tools
- Opening and closing the system
- Inside the system
- Cooling fans
- Hard drives
- SATADOM
- Power supply units
- System board assembly
- Air baffle
- Heat sinks
- Processors
- Expansion card assembly and expansion card
- Riser card
- LSI 2008 Mezzanine Card
- Mezzanine card bridge board
- System memory
- System battery
- System board
- Troubleshooting your system
- Safety first—for you and your system
- Minimum configuration to POST
- Safety first – for you and your system
- Installation-related issues
- Troubleshooting system startup failure
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting a serial I/O device
- Troubleshooting a NIC
- Troubleshooting a wet system
- Troubleshooting a damaged system
- Troubleshooting the system battery
- Troubleshooting PSUs
- Troubleshooting system cooling issues
- Troubleshooting a fan
- Troubleshooting system memory
- Troubleshooting a hard drive
- Troubleshooting a storage controller
- Troubleshooting expansion cards
- Troubleshooting processors
- IRQ assignment conflicts
- Jumpers and connectors
- Getting help
Memory slot features
• Support 8 channels, 16 DDR4 registered DIMMs (RDIMMs)
• Speed up to 2400 MT/s
• Max. capacities:
512 GB with 32 GB RDIMM
• Supports DDR4
• Supports Error Correction Code (ECC)
NOTE: Linux operating system does not support the S4 (hibernation) mode.
Supported memory module configuration
For the sequence of the 16 memory-module sockets, the system requires at least one memory module
installed on processor 1’s DIMM slot 1 in order to boot up. When you insert the memory modules, always
start with CHA_A1. The optimized memory module installation sequence is 1, 2, 3, 4, 5, 6, 7, and 8.
Figure 30. DIMM slot locations
Table 10. Memory module configurations for dual processors
Processor 1
Memory
modules
CHA CHB CHC CHD
A1 A5 A2 A6 A3 A7 A4 A8
2 √ ‒ ‒ ‒ ‒ ‒ ‒ ‒
66