Users Guide

10 Fabric Manager for XC Xpress User’s Guide | A02
Term
Definition
IP routing
Tool that reports the configured routes on the switch.
Firewall Check
This test only executes if the tool detects that it is running on Windows XC node. XC
needs the following ports to be open for the foundation and discovery to work properly.
The tool will open these ports on Windows firewall.
 UDP on port 13000 (Nutanix discovery protocol)
 TCP on ports 8000 (Foundation GUI)
 TCP on 9442 (proxy)
 TCP on 9443 (applet control)
Details
The Details section reports the configured interfaces with IP address and VLANs to port
mapping.
If your switch is not a validated switch, do the following manual steps:
1. Verify you have a 1/10 G capable network.
2. Verify you have IPv6 enabled.
3. Verify your management workstation is on the same subnet as your appliances.
4. Verify that the TCP/UDP ports are enabled.
If the above verifications fail, correct any issues or contact your Dell sales representative to purchase a validated switch.