Owners Manual

Figure 33. Removing a redundant PSU

1 release latch 2 PSU connector

3 PSU 4 power connector

5 PSU handle

Next steps

Install the PSU.

NOTE

: If you are removing the PSU permanently, install a PSU blank.

Related links

Safety instructions

Installing a redundant power supply unit

Prerequisites

1 Follow the safety guidelines listed in the Safety instructions section.

2 Verify that both power supply units (PSUs) are of the same type and have the same maximum output power.

NOTE

: The maximum output power (Watt) is listed on the PSU label.

3 If installed, remove the PSU blank.

Steps

Slide the new PSU into the chassis until the PSU is fully seated and the release latch snaps into place.

Installing and removing system components