Owners Manual

Figure 23. Installing a hard drive into a hard drive carrier

1 screw (4) 2 hard drive

3 hard drive carrier

Next steps

Install the hot swappable hard drive carrier.

Related links

Installing a hot swappable hard drive carrier

Cooling fans

Your system supports:

• Up to four cooling fans in a non-redundant power supply unit (PSU) conguration.

• Up to ve cooling fans in a redundant PSU conguration.

NOTE

: Fan 1 must be installed in a redundant PSU

conguration.

NOTE: Hot-swap removal or installation of the fans is not supported.

NOTE: Each fan is listed in the systems management software, referenced by the respective fan number. If there is a problem

with a particular fan, you can easily identify and replace the proper fan by noting the fan numbers on the cooling fan assembly.

Removing a cooling fan

Prerequisites

NOTE

: The procedure for removing each fan is identical.

1 Follow the safety guidelines listed in the Safety instructions section.

2 Follow the procedure listed in the Before working inside your system section.

3 Remove the cooling shroud.

4 If required, remove the cooling shroud.

Steps

1 Disconnect the power cable from the power connector on the system board or power interposer board.

2 Lift the fan out of the cooling fan bracket.

Installing and removing system components