Owners Manual

Removing a hard drive or a solid state drive from a hard drive
carrier
Prerequisites
1 Keep the Phillips #1 screwdriver ready.
2 Remove the hot swappable hard drive carrier from the system.
Steps
1 Remove the screws from the slide rails on the hard drive carrier.
2 Lift the hard drive out of the hard drive carrier.
Figure 22. Removing a hard drive from a hard drive carrier
1
screw (4) 2 hard drive
3 hard drive carrier
Next steps
If applicable, install a hard drive into the hard drive carrier.
Related links
Removing a hot swappable hard drive carrier
Installing a hard drive or solid state drives into a hard drive
carrier
Prerequisites
Steps
1 Insert the hard drive into the hard drive carrier with the connector end of the hard drive toward the back of the carrier.
2 Align the screw holes on the hard drive with the screws holes on the hard drive carrier.
When aligned correctly, the back of the hard drive is ush with the back of the hard drive carrier.
3 Attach the screws to secure the hard drive to the hard drive carrier.
40
Installing and removing system components