Owners Manual

Installing the cooling shroud

Prerequisites

1 Follow the safety guidelines listed in the Safety instructions section.

2 Follow the procedure listed in the Before working inside your system section.

3 If applicable, route the cables inside the system along the chassis wall and secure the cables by using the cable-securing bracket.

Steps

1 Align the tabs on the cooling shroud with the securing slots on the chassis.

a Align the cooling shroud with the guide pin on the system board.

b Align the intrusion switch with the intrusion switch connector on the system board.

2 Lower the cooling shroud into the chassis until it is rmly seated.

When rmly seated, the memory socket numbers marked on the cooling shroud align with the respective memory sockets.

Figure 15. Installing the cooling shroud

cooling shroud 2 intrusion switch

3 intrusion switch connector on the system board 4 guide on the cooling shroud

5 guide pin

Next steps

1 Follow the procedure listed in the After working inside your system section.