Owners Manual

Removing the cooling shroud

Prerequisites

1 Follow the safety guidelines listed in the Safety instructions section.

2 Follow the procedure listed in the Before working inside your system section.

3 If installed, remove the full-length PCIe card.

Steps

Holding the touch points, lift the cooling shroud away from the system.

Figure 14. Removing the cooling shroud

cooling shroud 2 intrusion switch

3 intrusion switch connector on the system board 4 guide on the cooling shroud

5 guide pin

Next steps

1 Install the cooling shroud.

2 If required, install the full-length PCIe card.

3 Follow the procedure listed in the After working inside your system section.