Owners Manual

3 Fit the free end of the bezel onto the system.

4 Lock the bezel by using the key.

Figure 10. Installing the optional front bezel

bezel lock 2 front bezel

System cover

The system cover protects the components inside the system and helps in maintaining air ow inside the system. Removing the system

cover activates the intrusion switch.

Removing the system cover

Prerequisites

1 Follow the safety guidelines listed in the Safety instructions section.

2 Turn o the system, including any attached peripherals.

3 Disconnect the system from the electrical outlet and disconnect the peripherals.

4 If installed, remove the optional bezel.

Steps

1 Rotate the latch release lock counter clockwise to the unlocked position.

2 Lift the latch toward the back of the system.

The system cover slides back and the tabs on the system cover disengage from the slots on the chassis.

NOTE

: The position of the latch may vary depending on the conguration of your system.

3 Hold the cover on both sides, and lift the cover away from the system.

Installing and removing system components