Deployment Guide

4 Dell EMC Xpress Hyper-Converged Deployment Checklist | A02
1 Introduction
Use this worksheet to collect your deployment data prior to installation.
For more information about Xpress documentation, including Acropolis guides, see the Xpress Support
Matrix at www.dell.com/xcseriesmanuals and select your Xpress appliance.
1.1 Default / set up cluster credentials
The default cluster credentials for the system differ from those stated at the beginning of all Nutanix
documentation. See Table 1 for default cluster credentials, which are specific to the system.
Default / set up cluster credentials
Interface
Target
Username
Password
Web management
console
iDRAC
root
calvin
Hyper-V appliance
Appliance
administrator
nutanix/4u
ESXi/AHV
Appliance
root
nutanix/4u
SSH client
Nutanix Controller VM
nutanix
nutanix/4u
Nutanix Web Console
PRISM Interface (after
cluster configuration
admin
admin
Follow your password security procedures to save your password. You cannot log in without the proper password. See the Nutanix Web
Console Guide on the Nutanix web site.
Note: If your iDRAC management and production network have the same subnet mask and default gateway,
they will share the same IP subnet mask and default gateway.
Deployment worksheet
IP Addresses (Per appliance)
Appliance 1
Appliance 2
Appliance 3
Appliance 4
(if applicable*)
Service Tag
CVM IP
Hypervisor IP
iDRAC IP
*If applicable means if you have a four appliance configuration. Minimum requirement is for three appliances.