Deployment Guide

11 Dell EMC XC Xpress Hyper-Converged Appliance Deployment Guide for ESXi | A02
c. Set Enable IPMI Over LAN to Enabled.
Note: It is not required to set the iDRAC IP information at this time. You can do it during cluster creation.
6. Scroll down the iDRAC Settings menu and configure the IPv4 Settings. This is where you can
configure your iDRAC IP addresses.
7. To return to the iDRAC Settings page, click Back.
8. To return to the System Setup page, click Finish.
9. To save changes, click Yes.
10. After it reports that the settings were saved successfully, click Yes.
Note: The tasks below describe the configuration using a remote virtual console launched from the iDRAC
WEB interface. In addition, you can use a directly attached monitor to configure each server and to start on
a bootable USB device with an ISO file to install an operating system.
11. You may log out of System Setup menu at this time.
12. Go to Logging in to Dell iDRAC.