Owners Manual

Figure 13. Installing the memory module
1. memory module 2. alignment key
3. memory module socket ejector (2)
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in After working inside your system.
3. Press F2 to enter System Setup, and check the System Memory setting.
The System Memory Size indicates the installed memory.
4. If the System Memory Size is incorrect, one or more of the memory modules may not be installed
properly. Ensure that the memory modules are firmly seated in their sockets.
5. Run the system memory test in the system diagnostics.
SATADOM
A SATADOM is a disk-on-module (DOM) form factor with an incorporated standard SATA data
connection. By default, the SATADOM comes with a power cable installed and is set in a Read/Write
position.
The SATADOM uses an onboard SATA controller and does not require an additional controller.
With Nutanix, you can locate the boot device on a separate controller from the data drives, which
improves system disk performance.
Important information about SATADOM
The SATA Disk‐On‐Motherboard (SATADOM) shipped with XC Series appliances is intended as an
appliance boot device.
53