Reference Guide
Table Of Contents
- Dell Wyse Management Suite Version 1.4 High Availability Guide
- Introduction
- High availability architecture
- High availability on Windows Server 2012/2016
- Achieve high availability on Windows Server 2012/2016
- Achieve high availability for MySQL InnoDB
- Achieve high availability on MongoDB
- Achieve high availability for Teradici devices
- Install Wyse Management Suite on Windows Server 2012/2016
- Upgrade Wyse Management Suite version 1.3 to 1.4
- Post installation checks
- Troubleshooting
Install Wyse Management Suite server
Ensure that the following components are congured before you install Wyse Management Suite server:
• Windows Failover Cluster on two Nodes
• MongoDB Server is running with replica set
• MySQL InnoDB Cluster set-up is running
• MySQL Router isinstalled on the two Nodes
Do the following to install Wyse Management Suite server:
1 Launch the Wyse Management Suite installer screen.
2 Select Custom Type and Teradici EMSDK and then click Next.
3 Select the External MongoDB option (MongoDB Cluster with Replica set that you have created. For example, wms. Type the Remote
Primary Mongo DB server information, Port number, and MongoDB Username and password in the respective elds and then click
Next.
4 Select the External MariaDB option for MySQL. Use MySQL router address (Local Host if it is installed on Wyse Management Suite
server node).
NOTE: Ensure that the Stratus user account is created on MySQL server.
5 Type MySQL Router information in the External Maria DB Server elds with the port number. Type the MySQL database user
account information that you have created initially. The Port Selection screen is displayed with the port details. This port is used by
MySQL Router. The default port is 6466. However, you can also change the port number.
6 Type the user name that has administrative privileges and e-mail address with the Teradici EMSDK port number and CIFS user
account information.
7 Type the Destination Installation folder path and Shared UNC path for the local repository and then click Next. The message The
installation was successful is displayed.
NOTE
: The shared UNC path should be kept out of both the Windows Server where Wyse Management Suite
application is installed.
NOTE: Before you install Wyse Management Suite application on Node 2, make sure to delete the ‘Data’ folder present
in the Wyse Management Suite Local Repository; which was created during installation on Node 1. After ‘Data’ folder is
deleted from the shared UNC WMS Local Repository path, you can install Wyse Management Suite Application in the
Node 2 of the Windows Cluster.
Achieve high availability for Teradici devices 67