Deployment Guide
Deploy and congure Wyse Management Suite
This chapter describes the deployment and conguration of Wyse Management Suite on a single server.
The tasks involved in deploying Wyse Management Suite on a single server are:
• Preparing the server
• Conguring DNS
• Installing Wyse Management Suite
Perform the following steps to deploy Wyse Management Suite on a single server to support 1,20,000 devices:
1 Log in to the system. Navigate to the Network Connections window and verify that the server has four network connections
available.
The following window is displayed:
Figure 6. Congure IP address
2 Congure each network connection with an IP address such that Ethernet0 has the primary IP address IP0 that is used by the Wyse
Management Suite.
3 Assign Ethernet1, Ethernet2, and Ethernet3 to the remaining three IP addresses – IP1, IP2, and IP3 that are used by front-end
MQTT.
4 Congure DNS with two DNS records. For example,
Xyz.wysemanagementsuite.com
Assigned with the primary IP address assigned to Ethernet0.
This domain is used by the devices to communicate with Tomcat over HTTPS.
Xyz-pns.wysemanagementsuite.com
Round robin between three IP addresses assigned to Ethernet1, Ethernet2, and Ethernet3.
This domain is used by the devices to establish a connection with the front-end MQTT servers.
5 Download and install the latest Wyse Management Suite for a private cloud. The following components are installed as services:
12
Custom port congurations