Deployment Guide
Deploying and conguring Wyse Management
Suite
This chapter describes the deployment and conguration of Wyse Management Suite v1.1 on a single server to support up to 1,20,000
devices.
The tasks involved in deploying Wyse Management Suite v1.1 on a single server are:
• Preparing the server
• Conguring DNS
• Installing Wyse Management Suite v1.1
You need to perform the following steps to deploy Wyse Management Suite v1.1 on a single server to support 1,20,000 devices:
1 Login to your system using valid credentials. To check that the server has four network connections available, and get four IP
addresses that you can use to work with the server.
The following window is displayed.
Figure 6. IP address details
2 Congure each network connection with an IP address such that Ethernet0 has the primary IP address IP0 that is used by the Wyse
Management Suite v1.1.
3 Assign Ethernet1, Ethernet2 and Ethernet3 with the remaining three IP addresses – IP1, IP2 and IP3 that will be used by front end
MQTT.
4 You must congure DNS and the server requires two DNS records. For example,
Xyz.wysemanagementsuite.com
Assigned with the primary IP address assigned to Ethernet0.
This domain is used by devices to communicate with Tomcat over HTTPS.
Xyz-pns.wysemanagementsuite.com
5
10 Deploying and conguring Wyse Management Suite