Administrator Guide

Figure 9. Pull OS image screen
4 Click Prepare for Image Pull.
When the Pull OS Image command is sent, the client device receives an image pull request from the server. An image pull request message
is displayed on the client side. Click either of the following options:
• Pull after sysprep—The device restarts, and logs in to the operating system in a disabled state. Run the custom sysprep. After the
custom sysprep is complete, the device boots to merlin operating system and the image pull operation is performed.
NOTE
: This option is applicable for Windows Embedded Standard devices.
• Pull now—The device boots to Merlin operating system and the image pull operation is performed.
NOTE
:
• Wyse Device Agent and Merlin must be updated on the devices.
• Legacy on-premise gateway does not support the image pull operation. To use this feature, install the Wyse Management Suite
repository.
• BIOS pull is not supported for Dell manufactured Windows Embedded Standard and ThinLinux devices.
Managing devices 157