Administrator Guide
Figure 8. Remote Shadow(VNC)
The IP address and the port number of the target thin client is displayed in the Remote Shadow (VNC) dialog box.
NOTE: The default port number is 5900.
3 Change the port number of the target thin client.(optional)
4 Click Connect to initiate a remote session to the target thin client.
Tagging devices
Wyse Management Suite enables you to identify a device or group of devices by using the Tag Device option.
1 Click Devices.
The Device page is displayed.
2 Apply the lters to locate the preferred device. For more information, see Searching a device by using lter.
The preferred device list is displayed.
3 Select one or more devices. From the More Options drop-down list, click Tag Device.
The Set Device Tag window is displayed.
4 Enter the preferred tag name.
5 Click Set Tag.
Device compliance status
By default, the following colors are displayed as the device status:
• Red—when the registered device has not been checked in for more than seven days.
• Gray—When you apply any conguration policy to the device.
• Green—When you apply all the conguration policies to the device.
The default value can be changed from 1 to 99 days.
The Online Status option is located next to the device name. The following colors are displayed in the online status:
• Red—When the device has not sent its heartbeat for more than three attempts .
• Gray—When the device has not sent its heartbeat for more than two attempts but less than three attempts.
• Green—When the device sends its heartbeat regularly.
Managing devices
155