Administrator Guide

Conguring BIOS settings for Wyse 5070 thin client with
ThinLinux
Use the BIOS settings page to congure the BIOS settings for Wyse 5070 thin client with ThinLinux.
Table 211. Congure general settings
Option Description
Device Notes Enter the device notes in the provided eld. For example, property
ownership tag.
Table 212. Congure system settings
Option Description
Enable Audio Select this check box to enable the audio device.
Enable UEFI Network Stack Select this check box to enable UEFI Network Stack. For the
enabled NICs, the networking protocols are installed, and the pre-
OS and early OS networking features are available.
Integrated NIC From the drop-down list, select the preferred option. This option
controls the on-board LAN controller.
• Disabled: The internal LAN is disabled and is not visible to the
operating system if it does not have an IP address.
• Enabled: The internal LAN is enabled.
• Enabled w/PXE: The internal LAN is enabled with PXE boot.
NOTE: Dell recommends not to disable the integrated NIC
and integrated NIC 2.
Parallel Port From the drop-down list, select the option to determine how the
parallel port on the docking station operates.
• Disabled: Port is disabled.
• AT: Port is congured for IBM AT compatibility.
• PS2: Port is congured for IBM PS2 compatibility.
• ECP: Port is congured for extended capability port protocol.
NOTE: This option is available for extended chassis when
the add-on card is installed.
Serial Port 1 From the drop-down list, select the option to determine how the
serial port on the docking station operates. This option enables you
to avoid resource conicts between devices by disabling or
remapping the address of the port.
• Disabled: Port is disabled.
• COM1: Port is congured at 3F8h with IRQ 4.
• COM2: Port is congured at 2F8h with IRQ 3.
• COM3: Port is congured at 3F8h with IRQ 4.
• COM4: Port is congured at 2F8h with IRQ 3.
114 Managing groups and congurations