Administrator Guide

Table 143. Configuring reboot schedule
Option Description
Reboot Option Some BIOS settings requires the system to restart. From the
drop-down list, select one of the following options:
● Reboot immediately—The system restarts immediately.
● Reboot later—Select the Reboot Hour and Reboot
Minute to set the system restart time.
● Do not reboot—The system does not restarts.
Table 144. USB configuration
Option Description
Enable Front USB Ports Select this check box to enable the device attached to this
port. If you select this check box, the device is made available
to the operating system also. However, if the USB port
is disabled, the operating system cannot detect any device
attached to this port.
Enable Rear USB Ports Select this check box to enable the device attached to this
port. If you select this check box, the device is made available
to the operating system also. However, if the USB port
is disabled, the operating system cannot detect any device
attached to this port.
Table 145. Configuring power management settings
Option Description
Wake on AC From the drop-down list, select an option to specify how the
system must behave when AC power is restored after an AC
power loss. The available options are:
● Off
● Last
● On
Wake On LAN From the drop-down list, select an option to allow the thin
client to power up from the off state. You can trigger a thin
client to power up from the off state by using a LAN signal or
a wireless LAN signal.
Configuring device information
Use the Device Info page to set the device details.
Table 146. Configuring device information
Option Description
Location Enter the device location.
Contact Enter the device contact.
Custom 1 to 3 Enter the custom values.
Configuring Wyse Easy Setup settings
Use the Wyse Easy Setup page to configure the Wyse Easy Setup settings for the control panel and the user interface.
Table 147. Configuring system
76 Managing groups and configurations