Administrator Guide

Figure 8. Remote Shadow(VNC)
The IP address and the port number of the target thin client is displayed in the Remote Shadow (VNC) dialog box.
NOTE: The default port number is 5900.
3. Change the port number of the target thin client.(optional)
4. Click Connect to initiate a remote session to the target thin client.
Tagging devices
About this task
Wyse Management Suite enables you to identify a device or group of devices by using the Tag Device option.
Steps
1. Click Devices.
The Device page is displayed.
2. Apply the filters to locate the preferred device. For more information, see Searching a device by using filter.
The preferred device list is displayed.
3. Select one or more devices. From the More Options drop-down list, click Tag Device.
The Set Device Tag window is displayed.
4. Enter the preferred tag name.
5. Click Set Tag.
Device compliance status
By default, the following colors are displayed as the device status:
● Red—when the registered device has not been checked in for more than seven days.
● Gray—When you apply any configuration policy to the device.
● Green—When you apply all the configuration policies to the device.
The default value can be changed from 1 to 99 days.
The Online Status option is located next to the device name. The following colors are displayed in the online status:
● Red—When the device has not sent its heartbeat for more than three attempts .
● Gray—When the device has not sent its heartbeat for more than two attempts but less than three attempts.
● Green—When the device sends its heartbeat regularly.
Managing devices
145