Administrator Guide
Table 166. Video
Option Description
Primary Video Device Slot From the drop-down list, select your primary video device slot.
Table 167. USB configuration
Option Description
Enable Rear USB Ports Select this check box to enable the operating system to detect the
devices that are attached to the rear USB port. However, if the
USB port is disabled, the operating system cannot detect the
device that is attached to the rear USB ports.
NOTE: The USB keyboard and the mouse always work in
the BIOS setup irrespective of this setting.
Rear port Top Left Select this option to enable the upper left USB port on the back of
the thin client.
Rear port Top Right Select this option to enable the upper right USB port on the back
of the thin client.
Rear port Bottom Left Select this option to enable the bottom left USB port on the back
of the thin client.
Rear port Bottom Right Select this option to enable the bottom right USB port on the back
of the thin client.
Table 168. Configuring security settings
Option Description
Enable Admin Setup Lockout Select this option to prevent others from entering the setup when
an administrator password is set.
Table 169. Configuring power management settings
Option Description
Wake On LAN From the drop-down list, select any option to enable the thin client
to power up from the OFF state. You can trigger a thin client to
power up from the OFF state by using a LAN signal.
AC Recovery From the drop-down list, select any option to specify how the
system operates when the AC power is restored.
Table 170. Configuring wireless settings
Option Description
WLAN/BT Select this check box to enable the internal wireless devices.
Table 171. Configuring post behavior settings
Option Description
Numlock LED Select this check box to enable Num Lock light when the system
starts.
Keyboard Errors Select this check box to report keyboard related errors when the
system starts.
Fastboot Select this check box speedup the boot process by bypassing few
compatibility steps.
Extend BIOS POST Time Select this check box to create an extra preboot delay that enables
you to see post status messages.
Enable Full Screen Logo Select this check box to enable full screen logo.
Managing groups and configurations 83