Administrator Guide

Option Description

Sessions to connect automatically Select this option to automatically connect to the session.

NOTE: The name of the desktop or application is case

sensitive. Use a semicolon to separate the multiple

sessions which must be initialized automatically.

Reconnect At Logon From the drop-down menu, select your preferred option. You can

reconnect to both disconnected and active sessions. This option is

applicable only for Citrix.

Security Mode Select this option to set a security mode. From the drop-down

menu, select your preferred option. This option is applicable only

for VMware

Protocol Select this option to choose a protocol. From the drop-down

menu, select your preferred option. This option is applicable only

for VMware.

Enable vWorkspace Gateway Select this option to enable vWorkspace gateway functionality.

This option is applicable only for vWorkspace.

ThinOS—Advanced mode

Use this page to configure the advanced policy settings for the ThinOS devices. To configure the advanced policy settings, do the

following:

1. Select Advanced Configuration as the mode of configuration.

2. The following are the available policy settings on the ThinOS page.

Figure 4. ThinOS—Advanced mode

• Device Configuration

• Advanced Device Configuration

• Remote Connection (Legacy)

• Remote Connection (8.5+)

• Printers (8.5+)

• Network Settings (8.5+)

3. Click Save & Publish to save your changes.

4. Click Remove Policy to go back to the ThinOS page.

5. Click Cancel to go back to the Groups & Configs page.

Managing groups and configurations