Administrator Guide

The IP address and the port number of the target thin client is displayed in the Remote Shadow (VNC) dialog box.
NOTE: The default port number is 5900.
3. Change the port number of the target thin client.(optional)
4. Click Connect to initiate a remote session to the target thin client.
Shutting down devices
Wyse Management Suite enables you to shut down the devices such as, Windows Embedded Standard, ThinLinux, and ThinOS thin
clients.
1. Click Devices.
The Device page is displayed.
2. Apply the filters to locate the preferred device. For more information, see Searching a device by using filters.
The preferred device list is displayed.
3. From the More Options drop-down list, click Shutdown Now.
The remote command to shut down the device is sent to the selected device. The device responds to the server and the command is
applied successfully.
NOTE: The Shutdown Now option is not enabled for thin clients running on Linux operating system.
Tagging devices
Wyse Management Suite enables you to identify a device or group of devices by using the Tag Device option.
1. Click Devices.
The Device page is displayed.
2. Apply the filters to locate the preferred device. For more information, see Searching a device by using filter.
The preferred device list is displayed.
3. Select one or more devices. From the More Options drop-down list, click Tag Device.
The Set Device Tag window is displayed.
4. Enter the preferred tag name.
5. Click Set Tag.
Device compliance status
By default, the following colors are displayed as the device status:
• Red—when the registered device has not been checked in for more than seven days.
• Gray—When you apply any configuration policy to the device.
• Green—When you apply all the configuration policies to the device.
The default value can be changed from 1 to 99 days.
The Online Status option is located next to the device name. The following colors are displayed in the online status:
• Red—When the device has not sent its heartbeat for more than three attempts .
• Gray—When the device has not sent its heartbeat for more than two attempts but less than three attempts.
• Green—When the device sends its heartbeat regularly.
Pulling Windows Embedded Standard or ThinLinux
image
Use the Wyse Management Suite to pull an operating system or BIOS from a thin client.
NOTE: You can upgrade ThinLinux from 1.x to 2.x.
Prerequistes:
• If you are using Wyse Management Suite 1.3 remote repository, then Recovery/ Recovery + OS pull template are not available in the
repository. You must upgrade Wyse Management Suite to 1.4 or later versions to access the templates.
Managing devices
153