Administrator Guide

Tag a device
Wyse Management Suite enables you to identify a device or group of devices by using the Tag Device option.
Steps
1. Click Devices.
The Device page is displayed.
2. Apply the filters to locate the preferred device.
The preferred device list is displayed.
3. Select one or more devices. From the More Options drop-down list, click Tag Device.
The Set Device Tag window is displayed.
4. Enter the preferred tag name.
5. Click Set Tag.
Device compliance status
By default, the following colors are displayed as the device status:
● Red—when the registered device has not been checked in for more than seven days.
● Gray—When you apply any configuration policy to the device.
● Green—When you apply all the configuration policies to the device.
The default value can be changed from 1 day to 99 days.
The Online Status option is located next to the device name. The following colors are displayed in the online status:
● Red—When the device has not sent its heartbeat for more than three attempts .
● Gray—When the device has not sent its heartbeat for more than two attempts but fewer than three attempts.
● Green—When the device sends its heartbeat regularly.
Pulling Windows Embedded Standard or ThinLinux
image
Prerequisites
● If you are using Wyse Management Suite 1.3 remote repository, then Recovery/ Recovery + OS pull template are not
available in the repository. You must upgrade Wyse Management Suite to 1.4 or later versions to access the templates.
● To perform ThinLinux image pull operation, you must close the Settings window in the ThinLinux device. You must perform
this operation before pulling an OS/OS+Recovery image from the ThinLinux device.
● To upgrade from ThinLinux 1.x to 2.x, the administrator must update the device with the latest WDA and merlin and then pull
the image. This pulled image must be used to upgrade from ThinLinux 1.x to 2.x.
● Ensure that the virtual machine where the server is running has sufficient memory to perform the pull and run the required
services for Wyse management Suite if you are using a local repository.
Steps
1. Go to the Windows Embedded Standard or ThinLinux device page.
2. Select Pull OS Image option, from the More Actions drop-down list.
3. Enter or select the following details:
● Name of Image—Provide a name for the image. To replace the image with a similar name and the image files which are
not completed successfully, click Override name.
● File repository—From the drop-down list, select the file repository to where the image is uploaded. There are two types
of file repositories:
○ Local repository
○ Remote Wyse Management Suite repository
● Pull Type—Select either Default or Advanced based on your pull type requirement.
60
Managing devices