Administrator Guide
Table 104. Power Management Settings
Parameter Description
AC Recovery Select the Power state from the drop-down list. This option
species the system’s behavior when AC power is restored after a
AC loss.
USB Wake Support Check-box to enable the USB devices to wake the system by
standby.
Wake On LAN / WLAN From the drop down list, select an option to allow the computer to
power up from the o state when triggered by a special LAN signal
or from the hibernate state when triggered by a special wireless
LAN signal.
Block Sleep Check-box. If enabled, it blocks the system from entering to the
sleep environment. The Intel Rapid start is disabled automatically,
and the OS power option is blank if it was set to sleep.
Table 105. BIOS Admin Password
Parameter Description
Enable Admin Password Check-box to enable BIOS administrator password. Successful
changes to this password take eect immediately.
Table 106. Auto On
Parameter Description
Auto On From the drop down list, set the time of day when you would like
the system to turn on automatically.
Table 107. POST Behavior
Parameter Description
Numlock LED Select this check-box to turn on the Numlock LED when the
system boots.
Keyboard Errors Select this check-box to report keyboard related errors when the
system boots.
Fastboot From the drop down list, select an option to speed up the boot
process by bypassing some compatibility steps. The available
options are:
• Minimal
• Thorough
• Auto
Extend BIOS POST Time From the drop down list, select an option to create an additional
pre-boot delay which allows the user to see POST status
messages. The available options are:
• 0 seconds
• 5 seconds
• 10 seconds
48 Managing Group Policies