Administrator Guide
Edge Gateway 5000 BIOS Settings
Use this page to dene Edge Gateway 5000 BIOS settings such as Wake-On-LAN, Auto-On, and Admin Password.
Table 52. General
Parameter Description
Device Notes Enter the device notes such as property ownership tag.
Table 53. System Conguration
Parameter Description
Integrated NIC From the drop-down list, select an option to control the on-board
LAN controller. The available options are:
• Disabled — The internal LAN is o and not visible to the OS.
• Force Disabled — The internal LAN is disabled and not visible to
the OS even if it has an IP address.
• Enabled — The internal LAN is enabled.
• Enabled w/PXE — The internal LAN is enabled (with Preboot
Execution Environment (PXE) boot).
Integrated NIC 2 From the drop-down list, select an option to control the on-board
LAN controller. The available options are:
• Disabled — The internal LAN is o and not visible to the OS.
• Force Disabled — The internal LAN is disabled and not visible to
the OS even if it has an IP address.
• Enabled — The internal LAN is enabled.
SMART Reporting Check box to control the reporting of hard drive errors for
integrated drivers during system startup.
Serial Port 1 RS232 Check box to determine how the built-in serial port operates. It lets
you avoid resource conicts between devices by disabling or
remapping the address of the port. This port is at 2D0h with IRQ 7.
Serial Port 2 RS422 Check box to determine how the built-in serial port operates. It lets
you avoid resource conicts between devices by disabling or
remapping the address of the port. This port is at 3E0h with IRQ 10.
Serial Port 3 RS485 Check box to determine how the built-in serial port operates. It lets
you avoid resource conicts between devices by disabling or
remapping the address of the port. This port is at 2E0h with IRQ 11.
Serial Port 4 RS485 Check box to determine how the built-in serial port operates. It lets
you avoid resource conicts between devices by disabling or
remapping the address of the port. This port is at 3E8h with IRQ 10.
Enable UEFI Network Stack Check box to install or make available the UEFI Networking
protocols, allowing pre-OS and early OS networking features to use
any enabled NICs. This may be used without switching on the PXE.
Watchdog Timer Support Check box to enable the Watchdog Timer feature.
WLAN Region Code Select appropriate region
Managing Group Policies 33