Administrator Guide
Parameter Description
Serial Port 1 RS232 Check box to determine how the built-in serial port operates. It lets
you avoid resource conicts between devices by disabling or
remapping the address of the port. This port is at 2D0h with IRQ 7.
Serial Port 2 RS422 Check box to determine how the built-in serial port operates. It lets
you avoid resource conicts between devices by disabling or
remapping the address of the port. This port is at 3E0h with IRQ 10.
Serial Port 3 RS485 Check box to determine how the built-in serial port operates. It lets
you avoid resource conicts between devices by disabling or
remapping the address of the port. This port is at 2E0h with IRQ 11.
Serial Port 4 RS485 Check box to determine how the built-in serial port operates. It lets
you avoid resource conicts between devices by disabling or
remapping the address of the port. This port is at 3E8h with IRQ 10.
Enable UEFI Network Stack Check box to install or make available the UEFI Networking
protocols, allowing pre-OS and early OS networking features to use
any enabled NICs. This may be used without switching on the PXE.
Watchdog Timer Support Check box to enable the Watchdog Timer feature.
WLAN Region Code From the drop-down list, select the WLAN region code.
Table 6. USB Conguration
Parameter Description
Enable USB 3.0 Ports Check box to enable the device attached to this port. The device is
also made available to the OS. If USB port is disabled, OS can not
see any device attached to this port.
Enable Top USB Port 1 Check box to enable the device attached to this port. The device is
also made available to the OS. If USB port is disabled, OS can not
see any device attached to this port.
Enable Top USB Port 2 Check box to enable the device attached to this port. The device is
also made available to the OS. If USB port is disabled, OS can not
see any device attached to this port.
Enable Bottom USB Port 3 Check box to enable the device attached to this port. The device is
also made available to the OS. If USB port is disabled, OS can not
see any device attached to this port.
Enable Boot Support Check box to allow the system to boot any type of USB Mass
Storage Devices (HDD, memory key, oppy). USB-aware OS always
see USB Mass Storage devices irrespective of this setting, provided
the port is enabled.
Table 7. Wireless Settings
Parameter Description
Enable WWAN Check box to enable Wireless Wide Area Network (WWAN).
Enable WLAN Check box to enable Wireless Local Area Network (WLAN).
Enable Bluetooth Check box to enable Bluetooth.
Enable CANBus Check box to enable CAN Bus.
20 Managing Group Policies