Administrator Guide
Table 60. Wireless
Parameter Description
Enable WWAN Select this check box to enable Wireless Wide Area Network
(WWAN).
Enable WLAN Select this check box to enable Wireless Local Area Network
(WLAN).
Enable Bluetooth Select this check box to enable Bluetooth.
Enable CANBus Select this check box to enable CAN Bus.
Table 61. Security
Parameter Description
Admin Setup Lockout Select this check box to prevent users from entering Setup when
the Admin password is set.
Chassis Intrusion Chassis Intrusion is a utility that the BIOS can use to tell you that
someone has opened the case. From the drop-down list, you can
select any of the following options:
• Disable—Disable chassis intrusion feature.
• Enable—Report intrusions during POST.
• On-Silent—Enable intrusion detection but does not display any
detected intrusion.
UEFI Capsule Firmware Update Select this check box to control allowing the BIOS updates through
UEFI capsule update packages by the system. Disabling this option
blocks the BIOS updates from services such as Microsoft Windows
Update and Linux Vendor Firmware Service (LVFS).
Table 62. BIOS Admin Password
Parameter Description
Enable Admin Password Select this check box to enable BIOS administrator password.
Successful changes to this password take eect immediately.
Table 63. Power Management
Parameter Description
AC Recovery From the drop-down list, select an option to specify how the
system behaves when AC power restored after an AC power loss.
The available options are:
• Power O
• Power On
• Last Power State
Wake On LAN From the drop-down list, select an option to allow the computer to
power up from the o state when triggered by a special LAN signal
or from the hibernate state when triggered by a special wireless
LAN signal.
Managing group and congs 37