Users Guide

Error messages Description
KEYBOARD DATA LINE FAILURE
For external keyboards, check the cable
connection. Run the Keyboard Controller test in
Dell Diagnostics.
KEYBOARD STUCK KEY FAILURE
For external keyboards or keypads, check the
cable connection. Restart the device, and avoid
touching the keyboard or keys during the boot
routine. Run the Stuck Key test in Dell
Diagnostics.
LICENSED CONTENT IS NOT ACCESSIBLE IN
MEDIADIRECT
Dell MediaDirect cannot verify the Digital Rights
Management (DRM) restrictions on the file, so the
file cannot be played.
MEMORY ADDRESS LINE FAILURE AT
ADDRESS, READ VALUE EXPECTING VALUE
A memory module may be faulty or improperly
seated. Reinstall the memory module or, if
necessary, replace it.
MEMORY ALLOCATION ERROR
The software you are attempting to run is
conflicting with the operating system, another
program, or a utility. Shut down the device, wait
for 30 seconds, and then restart it. Run the
program again. If the error message still appears,
see the software documentation.
MEMORY DOUBLE WORD LOGIC FAILURE AT
ADDRESS, READ VALUE EXPECTING VALUE
A memory module may be faulty or improperly
seated. Reinstall the memory module or, if
necessary, replace it.
MEMORY ODD/EVEN LOGIC FAILURE AT
ADDRESS, READ VALUE EXPECTING VALUE
A memory module may be faulty or improperly
seated. Reinstall the memory module or, if
necessary, replace it.
MEMORY WRITE/READ FAILURE AT ADDRESS,
READ VALUE EXPECTING VALUE
A memory module may be faulty or improperly
seated. Reinstall the memory module or, if
necessary, replace it.
NO BOOT DEVICE AVAILABLE
The device cannot find the hard drive. If the hard
drive is your boot device, ensure that the drive is
installed, properly seated, and partitioned as a boot
device.
NO BOOT SECTOR ON HARD DRIVE
The operating system may be corrupted
NO TIMER TICK INTERRUPT
A chip on the system board may be
malfunctioning. Run the System Set tests in Dell
Diagnostics.
NOT ENOUGH MEMORY OR RESOURCES. EXIT
SOME PROGRAMS AND TRY AGAIN
You have too many programs open. Close all
windows and open the program that you want to
use.
25