Service Manual

Rubber feet

Removing the rubber feet

Prerequisites

1. Follow the procedure in Before working on your thin client.

2. Remove the stand.

3. Remove the back cover.

4. Remove the VESA-mount.

5. Remove the solid-state drive.

6. Remove the wireless card.

7. Remove the heat sink.

8. Remove the system board.

9. Remove the speakers.

10. Remove the middle frame.

About this task

The following image indicates the location of rubber feet and provides a visual representation of the removal procedure:

Steps

1. Remove the two screws (M3x5) that secure the rubber foot to the display assembly.

2. Lift the rubber foot off the display bezel.

Installing the rubber feet

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

Removing and installing components