Service Manual

Steps

1. Align the slots on the middle frame with the slots on the chassis.

2. Slide the display cable through the slot on the middle frame.

3. Place the middle frame on the display assembly and press down until the tabs lock in place.

4. Replace the eighteen screws (M3x5) that secure the middle frame to the chassis.

5. Replace the eight screws (M3x3) that secure the middle frame to the display panel.

6. Connect the converter board cable to the display panel and route the cable on to the middle frame.

7. Route of the antenna, camera, and microphone cables on to the routing guides on the middle frame.

Next steps

1. Install the speaker.

2. Install the VESA-mount.

3. Install the system board.

4. Install the heat sink.

5. Install the wireless card.

6. Install the solid state drive.

7. Install the OSD board.

8. Install the back cover.

9. Install the stand.

10. Follow the procedure in After working on your thin client.

Removing and installing components